AW11 Front Trunk Prop Rod Kit Installation Instructions
Your kit will consist of the following items:
2x hydraulic prop rods w/ installation hardware pre-installed in
correct locations.
The brackets are as follows:
To install:
1. Pop front trunk and secure with stock prop rod (this is the last
time you will use it!)
2. Locate and remove the top-most bolt from the lid hinge. Place the
bolt through the hole in the bracket, securing it to the lid. The
bracket should look like this when completed:
3. Locate and remove the 3 10mm bolts from the fender as shown in this
picture.
4. Remove the safety clip from the ball joint socket rod end
if so
equipped (as shown HERE). Place the ball stud into hole #1
keeping
the stock bumper pad bracket in place. If desired (and so equipped) you
may place the nylon bolts in holes #2 and #3. Leaving them out will not
harm anything.
5. Place the large, body, end on the hinge bracket ball
stud and replace
the safety clip if so equipped.
6. Place the small, rod, end on the fender ball stud bolt and replace
the safety clip if so equipped.
7. Ensure that the body of the prop rod is above the rod like in this
picture:
8. Repeat on the opposite side.
If you so wish, you may remove the stock prop rod. The top quality
hydraulic rods are designed to last many many years and are virtually
maintenance free.